You can follow the steps below to learn how to install a toilet in your bathroom. This is a guideline only. Before you start, make sure to consult the product manual.
Measurements
To ensure that you buy the right size rough in, it is important to note down some measurements. Measure from the wall to nearest bolt ofitswaste outlet.
Locate A Toilet
There are many guides that will help you choose the right model for your needs and measurements. Below are a few buying guides to help you find the right fit.
If Necessary, Remove The Old Toilet
These steps will help you remove your old toilet if you have not done so.
- Make sure that water is off.
- After it is removed, you can start emptying the bowl and tank by flushing out the water. You can either use a pump to remove it or a cup to reduce the water level bit by bit. You can absorb any remaining water with a sponge.
- You will have one tank, one bowl and two separate pieces if you unscrew the bolts connecting the tank and bowl.
- Lock the bolts at yourloo’s base. You may need to loosen between two and four bolts depending on the age and brand of your model. This will allow you to remove it from the floor.
- It is possible that the bolts or the max that held it in place make base removal a little more difficult. You can try to remove the putty or max, but you may need to twist it as much as possible until it is gone.
- You will now be exposed to the waste pipe. To prevent overpowering gases entering your work area, you should cover the hole with something. Do not skip this step.
- Remove any wax residue from the base. Make sure the mounting plate is clear of clutter before you install your new one.
Installation Guide
Always read the instructions manual before installing your toilet.
- Mounting the bowl on the waste pipe outlet is the first task. You will need to apply the wax ring underneath the bowl. To prevent any damage to the bowl, ensure that you have padding underneath your unit when you turn it over to apply the wax.
- Mount it to the flange. Turn it over and remove any gasses or plugging that you may have placed into the waste pipe. Then, screw in the bolts. These washers don’t need to be tightened too much. You should also make sure you read the labels and the step-by-step guide to where each washer goes.
- To help the wax ring stay in place, press down on the bowl. After you have done this, tighten the washers/bolts mentioned in step 2.
- Sealant can be added to the base’s outskirts to prevent leakage.
- Now it’s time to install your tank. Take great care when installing the gasket at the tank’s base. Make sure to read and follow all instructions.
- Once you have attached the gasket, attach it to the bowl. These will typically include rubber washers and screws through the tank at the back of your bowl.
- Screw the seat onto the top. You may need to use different methods to secure the seats in place. Please refer to the manual.
- Attach the water supply line to the tank.
- To achieve an effective flush, adjust the lever to ensure it is not too tight or too loose.
- You are done.
This is a guideline of what you can expect at each step. To find clear, concise and well-labelled instructions with images that are supported by images, you should always read the step-by-step guide included with it. You could end up paying more in repair costs if you don’t do this.
